Welcome to WIFI Antennas

Register now to gain access to all of our features. Once registered and logged in, you will be able to contribute to this site by submitting your own content or replying to existing content. You'll be able to customize your profile, receive reputation points as a reward for submitting content, while also communicating with other members via your own private inbox, plus much more! This message will be removed once you have signed in.

Sign In Sign Up

Search the Community: Showing results for tags 'SPLITTER'.

  • Search By Tags

    Type tags separated by commas.

  • Search By Author

Content Type


Forums

  • Wired Network
    • Ethernet edge
    • Technical wired networks
  • Wireless network
    • Antennas for 2.4 GHz band
    • Antennas 5GHz band
    • Antennas for mobile communications
    • Modeling antennas
    • Modification of Wi-Fi equipment
    • Wi-Fi equipment in the work
    • Wi-Fi Soft
    • WarDriving
    • Brainstorm
  • About Others
    • Smoking Room
    • Buy / Sell / Exchange
    • HF, VHF and UHF

Categories

  • Articles

Calendars

  • Community Calendar

Blogs

There are no results to display.

Categories

  • Files

Found 1 result

  1. DVB-T2 Front End

    swarg_eu posted a topic in Buy / Sell / Exchange

    Selfmade RF frontend for Video signal (Analog, DVB-T, DVB-T2, CATV) amplification in a 75 Ohm system. The RF frontend contains the following building blocks: 4-Way Wilkinson power combiner - combines the signal from 4 antennas (~6dB gain) bandpass filter - eliminates the interfering radio signals (FM...) low noise amplifier with a voltage regulator - for sensitivity improvement (~21dB gain, NF~1dB ) Interconnections: 4 F type connector 75 Ohm inputs (antenna) 1 F type connector 75 Ohm output (receiver side), requires a bias voltage in the range of 6-20 VDC and ~60 mA (for example: ZS300 antenna power injector ) Technical data: Frequency range from ~460 to ~880 MHz Noise figure >2,5 dB (including insertion losses) Gain <25 dB (including insertion losses and combiner gain) P1dB ~19dBm Max Pin 17dBm Size ~250x120x25 mm The use of this RF frontend is recommended in one of the following scenarios: the picture is pixelated but you are already using a high gain antenna and amplifier you are in a high power RF environment, Amateur Radio, FM radio is attenuated by more than 80dB ... you want to combine the signal from multiple directions to a single cable (signal quality will/can be reduced) Basic knowledge in antenna (phase) arrays is recommended to exploit the benefits of the RF frontend. Protective housing not included. Antennas not included. Power injector not included. Coax cable not included. Test results (scenario with a pixelated picture and high power RF environment) DVB-T2 Transmitter side cordinates 45,89938 N; 15,94786 E; DVB-T2 Reciever side coordinates 44,47105 N; 17,97297 E; Link distance ~225 km, no line of sight. Receiver side 2x2 antenna array with Triplex Loga Iskra P-47N (without an amplifier, marked on radio tower picture), connected with ~1m RG-6/U coax cable (length variation between antennas <1cm) to RF frontend. Received signal strength (SNR) above the threshold including fading effects (SNR range 29-37 dB). Successful elimination of interfering radio signals (see measured transmission response) on the receiver side (4 FM station with 400 W ....) Free worldwide shipping with DHL.